ECE R44/04 EECE R44/04semi-universal 0-18 kg5CR 44 04200Complies with revised standard:Tested and ApprovedECE R44/04www.besafe.eu0+/1 0-186m
10Adjust the front brace outwards with the ratchet (6). Continue tightening until the brace is pressed well into the backrest of the car seat.Make sur
11Warning: Potential misuse!NEVER USE iZi Kid ISOx on a passenger seat tted with activated frontal airbag.NEVER use BeSafe iZi Kid ISOx without the
12BeSafe iZi Kid ISOx has 4 sitting positions.The sitting positions can be regulated by using the lever (5)Sitting positions Car seat protectionTo av
1313If your iZi Kid ISOx is installed in the back seat, push the front seat as far forward as possible. Adjust the backrest as far backwards as poss
145Push the switch (4) on each side, and push the ISOx installation connectors (7) into the base.6Pull the iZi Kid ISOx back towards the front seat.
15After an accidentAfter an accident, the iZi Kid ISOx must be replaced. Although it may look undamaged, if you were to have another accident, the i
16Pay attention when you remove the cover, as tting the cover is done in the opposite way.Removing and refitting the coverRemoving the coverNever use
17Cleaning harness and seatThe cover of the iZi Kid ISOx must be washed in accordance with the instructions (on the inside of the cover). Washing ins
18 !Important adviceDO NOT use on a passenger seat fitted with - activated frontal airbag.ALWAYS use the harness provided with the i
19 !KEEP this user manual for later use. -DO NOT attempt to dismantle, modify or add any part -to the iZi Kid ISOfix. DO NOT use anything, suc
2 !Vital informationVital information 2Preparing to install 4Before installation 6Installation in the car 8Waring: poten
2008 - v1.1This is a semi-universal ISOx CHILD RESTRAINT SYSTEM. It is approved to regulation No. 44.04, series of amendments for general use in vehi
3AIRBAGBeSafe recommends that child seats are not bought or sold second-hand. Second-hand car seatsDO NOT use on a passenger seat tted with activated
41. Internal harness2. Harness adjustment3. Front brace4. Switch for ISOx connectors5. Lever for sleeping positions6. Ratchet for front brace7. ISO
5Too highToo low CorrectClick!!Height adjustment of harness systemHeight can be adjusted by releasingthe height adjustment device on the back of the i
6Before installationWhen mounting in the back seat, push the front seat as far forward as possible. When mounting in the front seat, adjust the backr
7Remove the plastic caps (9) from the ISOx connectors (7) by pressing down the ISOx release Use the ratchet (6) to adjust the front brace to the in
8Installation in the car231Place the seat into the car by racing the seat with the front brace rst.BeSafe iZi Kid ISOx is installed the same way in
9Click the ISOx connectors in the ISOx anchorages. Pull both ISOx connectors (7) as far out as possible.45The switch (4) then goes into the lowest
Commentaires sur ces manuels